As a conscientious homeowner, you want assurance that the contractor
you hire will do a quality job. Asking questions can help. It is important
that you take time to ask questions about all aspects of your project
with a qualified contractor.
Several are listed here for your convenience.
Q. Will the excavated area
be a minimum of 6" (150 mm) wider than
the actual paved area?
A. Yes, when the aggregate base is placed in the excavated area, the
extra width will help ensure stability of the base at the edges, and
provide space for the required edge restraints.
Q. How will the contractor grade the paver installation for drainage?
A. By sloping the paved area away from the house at a minimum of 2%.
Q.
Will the aggregate base absorb or hold water?
A. No, when compacted properly, its density will minimize deformation
and/or heaving of the paved surface during freezing or thawing.
Q. Will the base be aggregate, ranging in size from approximately
3/4" (20
mm) to sand?
A. Yes, this facilitates compaction to a required density while allowing
proper water drainage.
Q. How will the aggregate base be compacted?
A. In 4" (200 mm) layers to achieve the maximum density and load
bearing capacity. Each layer will require several passes of a compactor
to achieve this.
Q. Will the bedding sand be loosely screeded to a depth of 1" (25
mm), but no thicker than 1 1/2" (40 mm) thick?
A. Yes, the loosely placed, even layer of washed, coarse sand provides
a setting bed for the pavers. When the pavers are placed on the sand
and compacted, the sand moves up into the joints. This causes the pavers
to interlock and become level after compaction. Note: limestone screenings
and stone dust should not be used for bedding sand.
Q. How will the contractor assure an even color mix of the paver?
A. By taking pavers from several bundles or pallets at a time.
Q. Will an edge restraint be installed?
A. Yes, an edge restraint around the perimeter of the pavers is essential
for eliminating horizontal creeping of the pavers and loss of bedding
sand.
Q. Are joints filled between the pavers?
A. Yes, with clean, fine sand. The sand should be dry sand so it will
flow freely into the joints. The pavers are compacted during and after
filling to begin interlock of the units and prevent sand from washing
from the joints.
Q. Should there be inspection of the pavers after their compaction?
A. Yes, the owner and the contractor should inspect the pavement together
and confirm the owner’s satisfaction.
Q. Do I need to seal the pavers?
A. No, pavers are extremely durable. Sealing, however, may enhance
the colors and may prevent staining. Allow a minimum of 60-90 days
after
completion of the installation before sealing. Consult your supplier
for recommendations on cleaning and sealing.
